Multi-tech-systems MT5600ZDX Manual do Utilizador descarregar pdf (Página 31)

Owners Manual

Command: Zn Modem Reset

Values: n = 0 or 1

Default: None

Description: Z0 Reset modem to profile saved by the last &W

command (profile 0).

Z1 Reset and restore stored profile 1.

Command: &Cn Data Carrier Detect (DCD) Control

Values: n = 0 or 1

Default: 1

Description: &C0 Ignores the state of carrier on the remote modem and

DCD circuit is always on.

&C1 DCD turns on when the remote modems carrier

signal is detected and DCD is off when the carrier

signal is not detected.

Command: &Dn Data Terminal Ready (DTR) Control

Values: n = 0, 1, 2, or 3

Default: 2

Description: &D0 Modem ignores the true status of the DTR signal and

responds as if it is always on.

&D1 When DTR drops while in online data mode, the

modem enters command mode, issues an OK, and

remains connected.

&D2 When DTR drops while in online data mode, the

modem hangs up (Auto-Answer is encumbered).

&D3 When DTR drops, the modem hangs up and resets as

if an ATZ command were issued.

Command: &Fn Load Factory Default Settings

Values: n = 0 or 1

Default: None

Description: &F0 Restore factory configuration 0.

&F1 Restore factory configuration 1.

Command: &Gn V.22bis Guard Tone Control

Values: n = 0, 1, or 2

Default: 0

Description: &G0 Disable guard tone.

&G1 Enable 550 Hz guard tone.

&G2 Enable 1800 Hz guard tone.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 83 84

Sem comentários

Multi-tech-systems MT5600ZDX Manual do Utilizador Página 31