Multi-Tech Systems ISI5634PCI/4/8 Manual do Utilizador descarregar pdf (Página 70)

ISI5634PCI/4/8 User Guide

LINUX-RPM: Verifying the ports

To test the installation, you can use the terminal program minicom.

Use the command minicom -s to set up the tty port that you will

use to communicate.

1. In the Configuration window, select Serial Port Setup.

2. Select A to set the Serial Device (for example, /dev/ttyM1a).

3. Select E to set the baud rate.

4. Press Escape (Esc) to exit.

5. Select Exit to communicate with the port.

6. Issue AT commands and make sure it returns OK.

LINUX-RPM: TTY Devices Created by the Drivers

Device files corresponding to ports on the ISI card are created in

the /dev folder. Use ttyMxy for normal ports. Normal ports

(ttyM) are configured for dial-in connections.

In these expressions (ttyMxy), the letter x is the card number (1-

4), and y is the port designator (a, b, c, ...).

The ISI Linux driver creates the following TTY devices in /dev

directory:

- /dev/ttyM1a TO /dev/ttyM1p for the first ISI card

- /dev/ttyM2a TO /dev/ttyM2p for the second ISI card

- /dev/ttyM3a TO /dev/ttyM3p for the third ISI card

- /dev/ttyM4a TO /dev/ttyM4p for the fourth ISI card

For the ISI5634PCI-4, it uses the following:

- /dev/ttyM1a TO /dev/ttyM1d for the first card

- /dev/ttyM2a TO /dev/ttyM2d for the second card

- /dev/ttyM3a TO /dev/ttyM3d for the third card

- /dev/ttyM4a TO /dev/ttyM4d for the fourth card

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 121 122

Sem comentários

Multi-Tech Systems ISI5634PCI/4/8 Manual do Utilizador Página 70